Fort Lauderdale Roof Pros provides professional chimney flashing in Fort Lauderdale, FL for residential and commercial properties across Broward County. Flashing is the one detail a city inspector can actually see. It goes in before the covering and gets looked at at dry-in, which makes it the honest test of whether a roof was built or merely finished. It is also where most Fort Lauderdale roof leaks start.
Done properly, a chimney gets step flashing woven course by course into the roof on the sloped sides, an apron at the low side, and counterflashing let into a cut reglet in the masonry so water running down the wall is thrown out over the step flashing. Done cheaply, it gets a bead of sealant where the two materials meet, which is not flashing at all — it is a maintenance item pretending to be a detail.
We do not reuse old flashing on a reroof, and we will not quote it that way. Metal that has spent twenty years in salt air and ultraviolet has thinned at the folds even where it looks intact, and the whole point of tearing off is to rebuild the parts nobody can reach afterwards. Reusing flashing saves a few hundred dollars and puts the failure back exactly where it was.
A wide chimney on the upslope side needs a cricket — a small framed and flashed ridge that splits water around the stack rather than letting it pond against masonry. On anything over roughly thirty inches of upslope width, code expects one, and on tile roofs the cricket has to be built high enough to work under the covering rather than tucked beneath it as an afterthought.
Almost everything above applies to any wall-to-roof junction, not just chimneys: a second-story wall landing on a lower roof, a parapet, a chase around a flue, a skylight curb. Add a kickout at the bottom of every such junction so water is thrown into the gutter instead of behind the cladding, because that missing piece of metal rots more walls here than anything else.
If your only symptom is a stain near a chimney, get it flashed rather than sealed. A reflash is a day's work on a sound roof and it lasts as long as the covering; sealant will bring you back next summer, and the summer after that, and by the third visit you will have paid for the flashing twice over without ever having had it.
Our licensed and insured team brings the right materials and equipment to every job — Miami-Dade NOA-approved assemblies, ASTM D1970 self-adhered underlayment, 8d ring-shank deck re-nailing, TAS 100(A) rated ridge vents, 26-gauge Galvalume standing seam panels, stainless steel tile fasteners — and backs the work with a written workmanship warranty. We serve Fort Lauderdale and nearby communities including Hollywood, Pembroke Pines, Coral Springs, Miramar.
What We Handle
Everything our chimney flashing in Fort Lauderdale covers
One crew, one point of contact, and the full range of chimney flashing work in Fort Lauderdale, FL. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair Fort Lauderdale
- chimney leak repair
- step and counterflashing
- reglet counterflashing
- chimney cricket
- chimney chase leak
- reflash chimney
- kickout flashing
- masonry flashing joint
- chimney cap and crown
- wall-to-roof flashing
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Fort Lauderdale services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with Miami-Dade NOA-approved assemblies, ASTM D1970 self-adhered underlayment, 8d ring-shank deck re-nailing, TAS 100(A) rated ridge vents, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Fort Lauderdale job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Broward County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Fort Lauderdale
Fort Lauderdale Roof Pros covers Fort Lauderdale and the surrounding communities of Broward County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in Hollywood, FL — Broward County, population 153,067
- Chimney Flashing in Pembroke Pines, FL — Broward County, population 171,178
- Chimney Flashing in Coral Springs, FL — Broward County, population 134,394
- Chimney Flashing in Miramar, FL — Broward County, population 134,721
- Chimney Flashing in Pompano Beach, FL — Broward County, population 112,046
- Chimney Flashing in Davie, FL — Broward County, population 105,691
Start on the Fort Lauderdale Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Fort Lauderdale Chooses Fort Lauderdale Roof Pros
- ✓We name the product approval or Notice of Acceptance on the estimate, before anything is ordered
- ✓Damaged area measured against total roof area, so the repair-or-replace call is arithmetic
- ✓Fastening schedules written from the approval document, not from crew habit
- ✓Code-driven costs such as deck re-nailing itemised separately from anything optional
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Fort Lauderdale follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Fort Lauderdale gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Fort Lauderdale, or request a quote and we'll get right back to you.